All posts in Industry News

The following is taken from the Department Environment & Primary Industries Website

In 2011 the Victorian Government announced a $750 million Powerline Bushfire Safety program (PBSP). The 10-year program will deliver on recommendations (27 and 32) of the 2009 Victorian Bushfire Royal Commission and aims to reduce the risk of bushfires caused by electrical assets without causing significant impact on electricity supply reliability.

As part of the project, electricity businesses will also invest an estimated $500 million on new generation electrical asset protection and control equipment. The report of the PBST showed that these new technologies would have the fastest and largest impact on risk reduction.

The program also includes:

  • Changes to network operations to prevent bushfire starts at the times and locations of greatest risk, whilst minimising disruptions to customer supply.
  • A Government contribution of up to $200 million over 10 years towards the replacement of the most dangerous power lines in the State that would otherwise not have been replaced.
  • $40 million from Government to mitigate power reliability impacts on customers critically reliant on power – known as the Local Infrastructure Assistance Fund (LIAF).
  • A Government contribution of $10 million over 5 years to continue research and development to identify cost-effective risk reduction technologies and procedures.

Summer Safety for the 2012/13 fire season

To reduce the risk of powerline related bushfires and improve electricity supply reliability, new circuit breaker technology is being installed on powerlines around the state.

Powerlines in the areas of highest bushfire risk are progressively having their automatic circuit reclosers (ACRs) upgraded from manual to remote controlled technology. The ACRs enable automatic reconnection of power following a fault. The automatic reconnection under certain circumstances can create a spark where the powerline is in contact with the ground, which has been found to potentially cause bushfires in high risk areas, on high risk days.

On Total Fire Ban and Code Red Days during the 2012-13 fire season, ACRs on powerlines in high bushfire risk areas will be remotely or manually adjusted to prevent them from automatically reconnecting, significantly reducing the risk of a fire start. This safety measure is a recommendation of the Bushfire Royal Commission (recommendation 32). This significantly improves on the situation in 2011-12 when the ACRs in some areas of the network were disabled for the entire six weeks of the period of greatest fire risk.

The changes to safety settings mean customers in high risk areas may experience a delay in power restoration if a fault occurs on Total Fire Ban and Code Red days. The changes balance supply reliability with increased bushfire safety of the state’s electrical distribution network. The changes do not mean the power will be shut off to reduce the fire risk.

The following except is taken from the CFA website.  Please visit for more information on smoke alarms and electrical fire safety.

Only working smoke alarms save lives. Did you know that while you are asleep you are unlikely to smell smoke? A working smoke alarm is vital to making sure you will wake up in the event of a fire.

CFA, together with MFB and Duracell recommends:

  • Using long-lasting 9V alkaline batteries in your smoke alarm – by doing this you ensure year-round protection
  • Using the brush attachment on your vacuum cleaner to dust around the smoke alarm
  • Installing photo-electric smoke alarms rather than ionisation smoke alarms where possible
  • Testing smoke alarms once a month using a broom handle – the alarm should produce a beeping sound when the test button is pressed
  • Replacing all smoke alarms (both battery powered and 240v hard-wired) after ten years (the year of manufacture is displayed on the alarm)
  • Purchasing smoke alarms that meet Australian Standards. Look for the AS3786 marking

For more information, visit www.changeyourbattery.com.au

Do your kids know what to do when the smoke alarm goes off?

Take some time to remind family members what actions to take if they smell smoke or see flames inside the home.

Simple actions like getting down low and crawling under smoke save lives, and every family should have a home fire escape plan that identifies all possible escape routes.

Smoke alarms for the hearing impaired

Special smoke alarms are available for the hearing impaired. These may feature a flashing strobe light, and/or a vibrating pad that can be placed under the pillow to activate when the alarm sounds.

Hearing impaired smoke alarms can link with standard smoke alarms to alert all household members, regardless of hearing levels. When one alarm senses smoke, all will activate.

Other models are portable units that can be taken from one residence to another.

Smoke Alarm Subsidy

Profoundly deaf people can apply for a smoke alarm subsidy to help cover the costs of visual and vibrating smoke alarms.

The subsidy scheme is available until June 2012 and is funded by the State Government. Details and application forms are available through the Victorian Deaf Society.

– See more at: http://www.cfa.vic.gov.au/plan-prepare/smoke-alarms/#sthash.8HGnTrkN.dpuf